1.Cooling water circulation system
The outlet temperature of the cooling water of the condenser can generally reach above 37°C. The high-temperature water is cooled by the cooling tower to the inlet water temperature required for cooling the condenser of the chiller, and then sent to the chiller for recycling through the cooling water pump.

HVAC systems (or heating, ventilation and air conditioning systems) are responsible for heating, cooling or circulating air in all types of buildings, both residential and industrial. These systems usually have a considerable network of ducts to transport and distribute the air, so it is essential that these are well insulated for everything to work properly.

Using a pre-insulated duct CNC cutting machine will definitely improve your duct making efficiency. A pre-insulated duct CNC cutting machine is a computerized cutting machine that cuts fast and accurately.

This method is formed by improving the rubber and plastic insulation of traditional galvanized steel air ducts. The core is to improve the cutting method of rubber and plastic insulation boards. The four sides of the air duct are cut from the whole board, and the four corners are cut and connected at 45° to ensure that the The four sides of the insulation layer are at right angles to reduce the bonding seam.

1. Temperature Controller

The temperature controller is used for the control or protection of the unit. When the temperature reaches the set value, the switch automatically cuts off (or turns on) the circuit. In our products, the temperature control is often used, and the temperature of the water tank is used to control the start and stop of the unit. There are also some like antifreeze that require the use of a temperature controller.

As has been seen, in a distribution of ducts you can find some accessories that are part of it and condition its behavior. There are both for circular, oval or rectangular ducts.

Using a pre-insulated duct CNC cutting machine will definitely improve your duct making efficiency. A pre-insulated duct CNC cutting machine is a computerized cutting machine that cuts fast and accurately.

The upstream of the indoor ventilation system industry includes raw materials such as steel, plastic and electronic components; the downstream is mainly used in residential, office buildings, shopping malls, restaurants, subway stations, railway stations, factories, hospitals, schools, etc.

1.Gas-liquid separator
In the evaporator, as the liquid evaporates in the evaporator, the liquid changes into a gas. Due to the change of load, there may be a part of the refrigerant that is not fully evaporated, but will directly enter the compressor.

The air duct can be rectangular or circular. Any type of materials used in pipeline construction must have the characteristics of not transmitting fire, not releasing toxic gas in case of fire, and must be able to bear its weight, stress generated by handling, and vibration and erosion generated by air passing through its interior mechanically.

Production of variable diameter duct
The reducing pipe of the rectangular air duct has two types: single-sided eccentricity and double-sided eccentricity. The angle φ of the single-sided variable diameter should be less than 30%, and the included angle of the double-sided variable diameter should be less than 60%.

As PIR pre-insulated duct system is getting its way into the HVAC industry. The knowledge of duct fabrication is necessary for pre-insulated duct fabricatiors and air conditioning contractors. This article shows how to fabricate and install PIR pre-insulated duct systems by hand made.