How to reduce the loss of laser cutting machine?

The laser cutting machine will inevitably experience some loss after a long time of use. Once the loss is too heavy, it will affect the service life and use effect of the equipment parts, which indirectly leads to the poor cutting quality of the cutting machine equipment. So in the face of this situation, how to effectively reduce its use loss?

Before starting the laser cutting machine, push the beam to move forward and backward by hand, and the cart can move left and right without abnormal noise before it can be powered on. When finishing the work of the day, you should carefully clean up the waste and debris in the machine, so that the machine motion system can be prevented from being damaged by foreign objects. Clean up its moving parts to keep the machine in good working condition. The specific methods are as follows:

　　 1. No objects can be placed in the machine to avoid unnecessary damage to the machine.

　　2. Clean the dust and foreign matter on the metal tanker, metal shaft, sliding block and linear guide with cotton cloth, and then add lubricating oil, and carry out the reciprocating motion of the empty line.

　　3. Put a little lubricating oil on the screws, including the screws on the laser tube support and the reflector, which can facilitate the disassembly and assembly of the laser cutting machine during maintenance.

　　 Note: Do not add lubricating oil to timing belts, drag chains, air pipes, motors, sensors, lenses, and wires.

　　 So in general, if you want to effectively reduce the wear and tear of the laser cutting machine, you must do a good job in the lubrication and maintenance of each component, which can not only effectively reduce the wear and tear, but also Reduce its failure rate and extend its service life.