E-mail:Machine@chinaventech.com Expert for pre insulated duct CNC cutting machine.
With the development of the times, the industry's requirements for cutting accuracy and speed are getting higher and higher. Simple talents can no longer meet. The era of CNC cutting machines has gradually begun. We know that we use CNC cutting machines, but we are using cutting machines. What should I prepare before? The following are the preparations organized by the editor.
1: Adjust the oxygen to the necessary pressure, unnecessary secondary adjustments during use.
2: Before cutting, first level the workpiece and cut the workpiece into a certain gap below to make the cutting of iron slag easier. The preheating power should be adjusted according to the thickness of the plate, and the flame equity should be kept neutral. After adjustment, place your fingers on the vinyl cross-pipe joint of the trunk. If your fingers feel the pull, they can be attached to the vinyl inlet joint, indicating that the torch can be fired. If it can be used, it needs to be re-checked and adjusted.
3: The method of checking the wind line is to ignite and preheat the CNC flame cutting machine for proper preheating. The detailed requirements before cutting are as follows. When cutting, in order to prevent the manipulator from being burnt by splashing iron oxide, a baffle can be added when necessary.
4: Check whether the site meets the safety requirements, whether the torch, oxygen cylinder, vinyl cylinder (or ethylene generator and moderate prevention) rubber tube, pressure gauge, etc. are normal, and the gas cutting equipment is connected to the operating program. When the air wire is irregular, all valves must be closed, and the inner surface of the incision must be adjusted with a needle or other methods to make it smooth. The cut workpiece must not be placed on the cement board. Because the cement board will crack after preheating.
The metal cutting surface of the CNC flame cutting machine must be carefully removed from rust, dirt and oil. The control method is to first pull the intake hose out of the ethylene bend, then open the ethylene valve to heat the oxygen valve. For shooting-suction torches, check whether the torch is shooting or not. The cut must be flat for heat release and dross removal. Then open the cut-off oxygen valve and follow the shape of the cut-off oxygen flow (ie Kiel). The wind line must be a straight, transparent cylinder and an appropriate length.
YINGDE VENTECH INTELLIGENT EQUIPMENT CO., LTD. thinks that a good rule of thumb to determine whether you're working on a project.
You can always ask the experts for the most appropriate powder coating machine price INFO CENTER for your specific needs. Find the best support, prices and other to INFO CENTER solutions at Ventech Automatic Machine.
We are making INFO CENTER available to you at a very low price.
Quick Links
Products
Contact Us