E-mail:Machine@chinaventech.com Expert for pre insulated duct CNC cutting machine.
The cutting rate of CNC laser cutting machine is relatively fast when in use, and it can produce good quality. Its cutting accuracy is relatively high, its cutting speed is relatively fast, and it can guarantee good quality when using it. Because it is a numerical control operation, it can save a part of human resources, so it has certain advantages in use. Then its speed will affect the quality of the workpiece during cutting, so I will introduce it in detail next.
One, the cutting speed is too fast
1. The laser beam contacts the material for a short time, so it cannot be cut off. Generate sparks.
2. Some areas that can be involved can be cut, but some blind areas cannot be cut.
3. Layer the entire cut part, which will affect the overall quality.
4. The plate could not be cut off in time, cutting off the road with diagonal stripes on the section, resulting in the lower melting point.
Second, the cutting speed of the CNC laser cutting machine is too slow
1. The interaction time between the material and the laser increases, the cutting board is excessively melted, and the cut part becomes thicker.
2. The gap deformation is large, and excessive burning occurs in the small round or sharp corners, and the ideal cutting effect cannot be obtained.
3. The cutting efficiency is low, which affects the production capacity, but also greatly reduces the cutting efficiency, and even affects the production period.
3. Judgment method of cutting speed
1. Reasonable cutting speed: cutting sparks spread from top to bottom, the cutting surface is stable, and there is no slag at the bottom. Such a reasonable speed can ensure that the later use of the workpiece achieves good results.
2. The cutting speed is too fast: the cutting spark is inclined, which may cause some personal injury.
3. Cutting speed is too slow: cutting sparks do not spread and condense. This will affect the overall cutting quality.
The above is the specific introduction that the cutting speed of the CNC laser cutting machine will affect the quality of the workpiece. Different cutting speeds will affect the quality of the cut workpiece. Ensure that the cutting speed is relatively reasonable, so as to ensure that the cutting workpiece can meet the requirements when in use. In addition, cutting too fast or too slow will affect the quality of the workpiece.
As we have known for quite some time, the success of VENTECH in the future will depend greatly on our ability to strike a balance between valuable human insight and interaction with technology.
Visit YINGDE VENTECH INTELLIGENT EQUIPMENT CO., LTD. for the best in supplies: Ventech Automatic Machine.
Time is one of the biggest challenges cited by manufacturing INFO CENTER.
YINGDE VENTECH INTELLIGENT EQUIPMENT CO., LTD. has never compromised on the quality and the services provided to the customer.
With the market analysts, exports from YINGDE VENTECH INTELLIGENT EQUIPMENT CO., LTD. facilities in China will surpass the forecast.
Quick Links
Products
Contact Us