E-mail:Machine@chinaventech.com Expert for pre insulated duct CNC cutting machine.

Ten safety points of metal laser cutting machine operation

2022-05-11

VENTECH

In the operation of a laser cutting machine, whether it is production or processing, safety comes first. Especially in the operation of a metal laser cutting machine, once an accident occurs, no matter whether it is personnel safety, equipment, or processing, one party will always be affected.

Ten safety points for operating a metal laser cutting machine:

1. Operators must be trained to be familiar with the structure and performance of the equipment, and master the operating system knowledge.

2. Do not handle the material before it is irradiated or heated by the laser to avoid the potential hazards of smoke and steam.

3. When starting the equipment, the operator shall not leave the platform or take care of the platform without authorization. If you need to leave, stop the machine or turn off the power switch.

4. Meet the safety performance standards of ordinary cutting machines. Start the laser strictly in accordance with the laser start procedure.

5. Put the fire extinguisher in an easily accessible place. When the laser is not working, please turn it off or off. Do not place paper, cloth, or other flammable materials near the unprotected laser beam.

6. Before cleaning, do not process the laser-irradiated or heated materials to avoid the potential hazards of smoke and steam.

7. If an abnormality is found during processing, immediately shut down the machine, eliminate the fault or report to the supervisor in time.

8. Wear professional protective equipment as needed, and wear compatible laser goggles near the laser beam.

9. When using gas cylinders, avoid crushing the welding wire and avoid leakage accidents. The use and transportation of gas cylinders must comply with gas cylinder supervision regulations. Do not explode gas cylinders in the sun or near heat sources. When opening the bottle valve, the operator should stand next to the bottle mouth.

10. During maintenance, please observe the high-voltage safety regulations. According to standards and procedures, metal laser cutting machines should be maintained every 40 hours or weekly, and every 1,000 hours or 6 months. After turning on the power of the machine, press the X and Y directions to manually turn on the machine at a low speed, and check whether there is any abnormality.