loading

E-mail:Machine@chinaventech.com              Expert for pre insulated duct CNC cutting machine.

Shandong gantry CNC cutting machine manufacturers tell you the precautions during operation

   Gantry CNC cutting machine is currently widely used. Whether it is technology construction or industrial cutting, it is inseparable from the Gantry CNC cutting machine, but as the operation of the Gantry CNC cutting machine becomes more and more difficult High, you need to understand the installation precautions of the gantry CNC cutting machine in detail. Below, the Shandong gantry CNC cutting machine manufacturer will tell you the detailed answer.

  Shandong gantry type CNC cutting machine installation suggestion:

   1. After unpacking, put the plasma power supply on the left middle position and place the board on Below, place the control cabinet on the left and rear of the cutting machine so that the operator can see the entire cutting machine and the cutting process.

   2. Remove the left side drag chain package and place it parallel to the cutting machine.

  3. Use a spirit level to level the 6 random anchor bolt adjustment seats.

  4. Connect the power cord of the plasma power supply to the workshop power supply (three-phase 380V, 50HZ), the power is 8KW.

   5. Connect the ground wire of the plasma power supply to the grille or steel plate of the workbench.

   6. Connect the power cord of the control cabinet to the power supply of the workshop (three-phase 380V, 50HZ), the power is 3KW.

  7. Connect the plug on the back of the computer to the control cabinet accordingly.

   8. Install the monitor, connect the power and signal cables.

  9. Connect the inlet and outlet pipes and drain, so that the depth of the water in the tank reaches 80mm

  10. Connect the compressed air pipe to the air inlet connector of the plasma power supply, And adjust the air pressure to 5.0.

  11. Turn on the main power supply, control cabinet key switch, main power supply, display and plasma power supply in turn.

  12. Operate according to the plasma power manual, system operation manual and operation manual. When you are not proficient, do not modify the setting parameters in the system at will.

  13. If you find that the cutting quality is not good and cannot be solved, you should check the plasma cutting torch

   If the electrodes and nozzles are damaged in any way, please replace them.

   Regarding the installation suggestions of the gantry CNC cutting machine, the above is the detailed answer to everyone from the Shandong gantry CNC cutting machine manufacturer. I believe you will be sure after reading the above at this moment Have a deeper understanding of this, if you want to get more information, you can pay more attention to our website

are an important part of the society and they come in handy in any place where there are powder coating machine for sale in need of punching machine manufacturer.

Buy INFO CENTER assembly machine manufacturers products online from China at the best price from here Ventech Automatic Machine.

If you need any help in INFO CENTER powder coating system for sale, YINGDE VENTECH INTELLIGENT EQUIPMENT CO., LTD. can help you. We provide the best in class. Our design and services will enable you to create the ideal room that you have always wanted!

GET IN TOUCH WITH Us
recommended articles
knowledge INFO CENTER NEWS
no data

Contact Us

Tel : +86 757 29200196
Mobile : +86-189 27789653
E-mail : machine@chinaventech.com
Address : No. 3, Hongcha Road, Yinghong
Industrial Zone, Yingde, 513042, Qingyuan, Guangdong, ChinaYPE 2019

Better Touch Better Business

Contact Sales at  VENTECH.

Air Units

Call Us

+86  18927789653

Copyright © 2025 Yingde Ventech Intelligent Equipment Co., Ltd. | Sitemap
Customer service
detect